CA INSTA-CURE+ Glue
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Highly recommended for use when gluing wood to resin parts such as when assembling our Pier kits. Regular model glue will NOT work on resin kits. You'll also find tons of other uses for this glue around the house and shop!